350Z 03-08 Center Dash Gauge Pods

Description

350Z 03-08 Center Dash Gauge Pods
These 3D printed gauge pods allow you to run aftermarket gauges where the stock ones go.
Designed to fit three 52mm or 2 1/16 aftermarket gauge.
No cutting or modification is required and reuses the stock hardware. It will work on any 350Z 03-08. It will not work on any other year 350Z.
This listing comes with three gauge pod mounts.
This does not come with the gauges or any other interior trim. The listing is for the 3D printed parts only.
Installation is simple and requires basic hand tools. You remove the center dash trim, remove the stock gauges and install the gauge pod mounts. This print has mounts for screws built in so it fits in the OEM spot without any modification.  I designed this with an autometer 52mm gauge which is actually 52.4. If your gauge is too loose add a layer of tape around it until it fits, too tight sand until it fits.
Made out of ABS plastic the same material most automotive interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
I have many 3D printed gauge pod designs for the 350Z and G35. If your looking for something else check out the rest of my designs.
If you have any questions just ask!