Lexus GS300/400 Driver Vent Gauge Pod

Description

GS 300/400 Driver Vent Gauge Pod.
This 3D printed part goes in the driver dash vent. Designed to fit a 52mm or 2 1/16 gauge. This replaces the front part of the vent and still allows some air flow. This will work on any second generation GS 300 or GS400 it will not work on any other cars.
This listing is only for the 3D printed part. It doesn't come with the gauges or any interior trim.
Installation is simple. You remove front of the vent trim and take apart the back of the vent and replace the front with this. You reuse the top fin, bottom fin and one side trim piece(you won't see this until you take it apart).  I was able to get the front vent trim off without removing the dashboard. You can get the front of the vent off with trim removal tools. I also removed a few of the lower dash panels to make it easier. No cutting or modifications are required to install. I designed these with an autometer 52mm gauge which is actually 52.4. If your gauge is too loose add a layer of tape around it until it fits, too tight sand until it fits.
Made out of ABS plastic the same material most of the interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
I have many designs for the second generation GS. If you don't like this check out the rest of my designs!
If you have any questions just ask!